The TW-10522 and TW-10533 are very similar, the difference being that the 10522 uses a 9/16″ veneered center panel instead of a 1/4″ plywood, putting the panel closer to the face of the door. This design is not recommended for Inset Cabinets

The cross section below shows how your door may look, but the profiles you select will affect the final look of your door




Door Design TW10522
Panel Raise 9/16″ Veneered Panel
Framing Bead Design Specific
Edge Profile L-149
Specie Hard Maple
Finish Ginger with Brown Glaze
Drawer Front Design TW10522
Drawer Front Panel Raise Design Specific

Available Profiles

Edge Profiles:All
Framing Beads:None
Panels Raises:None - Design Specific 9/16" Flat Panel
Available Profiles PDF

Available Design Options

Mullion/Frame only Doors:Frame only OK. Mullions N/A. For mullions, order TW10533. Special lite charges apply for mullion doors
Wainscot Panels:Yes
Pegs and Grooves:Grooves OK. Pegs N/A
Appliance Panels:Yes
Door Frame Modifications:No
Hinges/Hinge Boring:Yes - Hinge boring is automatic when ordered with RTA cabinets, but no hinging can be requested. If ordering doors only, hinging must be specified.
Design Options PDF

Available Drawer Fronts