• 1/8″ thick sheet stock with Grade A face veneer applied over veneer core with sound back.
  • 1/4″ thick sheet stock with Grade A face and #1 back veneers applied over MDF core.
  • 3/4″ thick sheet stock with Grade A face veneer applied over veneer core with prefinished Natural Birch back, except where otherwise noted.
  • 3/4″ thick full sheets or cut-to-size panels over 96-1/6″ up to 120″ in length of  Hard Maple/Hard Maple will have an MDF core.
  • All 1/8″, 1/4″ and 3/4″ sheet stock is available in full 4′ x 8′ sheets, with the exception of Hard Maple/Hard Maple which is also available in 4′ x 10′ sheets. All sheet stock including 4′ x 10′ material is also available as cut-to-size panels.
  • Plywood finished in Colourtones may have pin marks and small scratches from drying racks, veneer checks, seam separation, glaze smudges, fingerprints, overspray and some dirt in topcoat. Such defects will be kept to a minimum, but are unavoidable when finishing large parts and will not be considered defective. 3/4″ thick edges will not be finished unless edgeband has been applied.
  • Lead-time 5 days cut-to-size, unfinished; 3 days for full sheets. Add 5-6 days for finishing.
  • Additional sheet stock is available through Special Designs in common species, grades and thickness in single sheet minimums. Specify thickness, core type, specie (face and back), veneer grade (face and back) and veneer cut (face and back). Lead-times and pricing are subject to availability.
  • Oversize packaging parameters and conditions apply when the size exceeds 36″ wide and 36″ long, the size exceeds 48″ wide or 84″ long, or when a customer requests oversize packaging.

Available Sizes



  • Available in full 4 x 8 sheets or cut to size

Hard Maple


  • Available in full 4 x 8 sheets or cut to size
  • Grooving available (1/4″ material only).
    • G-012, G-015 or G-056 groove profiles.
    • Spacing available in increments starting at 1/2″ up to 4″.

Hard Maple
Red Oak
Red Birch
White Birch
Bamboo, Carmelized
Knotty Pine
MDF (raw)
Quarter Sawn Red Oak
Quarter Sawn White Oak
White Oak


  • Available in full 4 x 8 sheet or cut to size
  • Edgeband charges (3/4″ plywood only):
    • .5mm edgeband 1 to 4 edge
    • 2mm edgeband 1 to 4 edges
    • For edgeband on specific edges of cut-to-size plywood, specify edges as follows: top, bottom, left, right or all edges.

Alder/Natural Birch back
Bamboo, Caramelized/Bamboo (MDF core)
Cherry/Natural Birch back
Cherry/Cherry back
Hard Maple/Natural Birch back
Hard Maple/Hard Maple back
Hard Maple/Hard Maple 120″ (MDF core)
Red Oak/Red Oak back
Rift Cut White Oak/Rift Cut White Oak back (MDF core)
Walnut/Wenge (MDF core)


  • Full sheet only, no cut to size
  • 96″ x 48″ panel for island back or wall panel applications.
  • Grain runs vertically in the 48″ direction.
  • 1/4″ thick material with Grade A face veneers applied over MDF core with sound back
  • Grooving not available

Hard Maple