Solid Wood Floating Shelf

• Solid Wood Floating Shelves are available in 24”, 30” and 36” lengths. Custom lengths not available.
• Each Solid Wood Floating Shelf is produced from domestic hardwoods and shipped ready for installation.
• Each shelf includes six 2-1/2” hex head lag screws, and installation instructions.
• The edges of the front and both sides are machined in one of three different randomly selected contoured patterns.
• The back of the shelf is routed and bored to accept and completely conceal the steel hanging bracket, allowing the shelf to fit flush against the wall.
• Solid Wood Floating Shelves are 1-3/4” thick and a depth reaching 10” at its deepest point. Due to the decorative contours machined into the front edge of the shelf there are areas that will be less than 10” in depth.
• All of Conestoga’s stains, paints, primers and glazed finishes are eligible.

Support Bracket
– Manufactured using high strength raw steel.
– 24″ and 30″ support brackets utilize two round steel support rods, 36″ support brackets utilize three round support rods.
– A small rare earth magnet is attached to the shelf back, which secures the shelf to the support bracket.
– It is imperative that support brackets be mounted to two wall studs using the six 2-1/2” long hex head lag screws included with the shelf.
– Maximum load capacity for the shelf and support bracket is 25 lbs. per linear foot. The load capacity of these shelves is dependent upon whether the support bracket is properly secured to the wall studs and the shelf. If the shelf is not secured to the support bracket properly, or the shelf is not secured into two wall studs using the six 2-1/2” long hex head lag screws, the shelf will not support the desired weight. Conestoga will not be responsible for shelf failure due to inadequate installation techniques or materials.